Farmall & IHC Tractors Discussion Board |
Re: Farmall A forklift
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on January 08, 2003 at 16:07:27 from (67.25.165.189):
In Reply to: Farmall A forklift posted by Murray on January 08, 2003 at 11:26:05:
Industrial forklifts usually weigh and one half times their rated load. Tilt cylinders are vital if you will be picking up logs or barrels on their side or anything round. If your load starts to roll off the tynes, it may lift the front end and shortly thereafter drop it. I suspect that your torque tube will be history at that point. I would guess 500 lbs would be a safe load for an A but it all depends on how close the load center is to your rear axel centerline. I have a 3000 lb tilting mast on my 650D and it works well. It is used mostly with a hydraulic utility pole auger. Hydraulic power comes from the PTO.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|