|
Farmall & IHC Tractors Discussion Board |
Re: How would a sickel bart mower mount to my h?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don LC on December 15, 2002 at 20:02:06 from (24.166.248.35):
In Reply to: How would a sickel bart mower mount to my h? posted by Sean Brinston on December 15, 2002 at 19:26:18:
If it is a rear mount IH mower , it will have a single rear wheel and a " V " angle frame.....it will bolt to your drawbar with two flat plates.....the mower will have what looks like a drawbar also....it bolts to the mowers V frame at each end.... the two plates bolt to the mower cross drawbar and too the tractor drawbar.....the rear mower wheel will swivel 360*.....mower will have a power takeoff shakt that will slide onto your tractor.....make sure this shaft has the long complete safety cover, that fastens to the PTO cover on your H.....you have to block it up when you mount an un mount it......I made adjustable leggs that I welded on mime.....that was about 50 years ago......
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
