Farmall & IHC Tractors Discussion Board |
torque problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bryce Andreasen on December 15, 2002 at 19:50:09 from (209.74.231.218):
I finaly got my 400 farmall after waiting two weeks. I went out on the highway, turned around and was getting back on after turning around on gravel road, and had to wait for a car so i put it in fifth gear with the torque back but it made a screaching noise and didn't move. Later on, I hooked on to our box scraper and put it on the ground. Put it in first gear with the torque ahead and started to pull. When it started to pull hard, i pulled it back and made the screaching noise again. But i put the clutch in and let it back out and finaly started moving again. I belive it is the overriding clutch in the TA that sometimes doesn't catch. I want to fix this so when I tractor pull i don't sitt half way down the track at a hault!
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|