|
Farmall & IHC Tractors Discussion Board |
Re: Compression too high?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on December 12, 2002 at 13:26:44 from (63.189.209.134):
In Reply to: Compression too high? posted by Mark on December 12, 2002 at 07:21:11:
Thanks for your comments. The possibilty the head was milled strikes me as logical to cause an increase in compression. However the engine has had very light duty since new. In my 25 years of ownership, the head (or anything else on the engine except points, plugs and ignition wires) has never been touched. The previous owner (and original purchaser) was a school in a small town. It was used only for mowing by them, so it was light duty there. I suppose there is a possibility the school messed up the engine somehow and had to have the head worked on before I got it. Next week I will be talking with the mechanic who used to work for me and recommended I by the tractor 25 years ago. He said then it was a good deal, and he has obviously been right. Since he lived in the small town where the tractor was and knew the sellers, I will ask him if the head had any work on it. Understand I am NOT complaining about the tractor in any way, shape or form! I am happy to have it and take good care of it. It is just that when I tested the compression I fully expected the psi to be lower than spec. The fact it is so much higher than spec really surprised me and I really would like some opinions on why this is so. To sum up: Your comments all make sense and I thank you. Rest assured I will not pull the head to take a look see. It runs great so leave it alone! Thanks to all of you. Mark
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|