|
Farmall & IHC Tractors Discussion Board |
Farmall H coil woes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayA on December 08, 2002 at 13:12:43 from (66.64.31.215):
Hello everyone. I ordered tune up stuff for the farmall and was putting them on today and have run into a problem. The tractor I am working on still has the 6V system. The coil that the dealer ordered for me looks different from my coil that came off the tractor. The new one looks more like a 12 volt coil to me. It is much bigger and the bracket holes are too wide to bolt correctly on the distributer. The box number for it is 396546R93 which I think is the correct number, but the number on the coil itself is 29690. The wire leads on the new coil (positive and negative) are on the same end as the coil wire. I resulted in putting my old coil on for now untill I can get it cleared up. Anyone else have this problem. Think it got boxed up wrong somewhere? Any info would be helpful. With new wires,plugs, points, rotor, and distributer cap it sounds alot better. Sure anxious to get that new coil on it. Thanks in advance, RAyA
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
