Farmall & IHC Tractors Discussion Board |
Re: M farmall pto seal, how to knock out old shaft seal?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on November 30, 2002 at 19:52:51 from (66.228.234.95):
In Reply to: M farmall pto seal, how to knock out old shaft seal? posted by aaron on November 30, 2002 at 15:05:38:
Just take your time and the shaft will find it's way home. You have to aim carefully; you can't hurt anything as long as the gasket isn't damaged. The PTO shaft has a 1/2" dia. extension on the end of the shaft that slips into a hole in the end of the transmission mainshaft. The seal can be replaced by removing just the end housing of the PTO . Carefully clean the splines on the outer end of the PTO shaft and file off any sharp edges BEFORE installing the new seal. A little grease helps to slip the seal and housing into place. Enjoy!!
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|