Farmall & IHC Tractors Discussion Board |
Re: Re: Painting H Farmall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john on November 25, 2002 at 18:40:18 from (192.233.162.197):
In Reply to: Re: Painting H Farmall posted by Dave_Id on November 25, 2002 at 16:37:41:
Use dupont 615+620 primer on bare metal, will give great adheasian. Next use Glaserite MS 285. This stuff will fill in small scratches and sand as smooth as glass. Next use Dupont Imron. I recomend single stage rather than base coat/clear coat because it may be hard to get clear everywhere or if you have to touch up,single stage is easier. You could use base coat/clear coat on the sheet metal but single stage imron will look great. Your tractor will shine and have that wet look. Then wet sand and buff the sheet metal. Imron will stand up to brake fluid. The only drawback is the material will cost around $750.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|