Re: Where can I get a sleeve puller?

Posted by mpj on November 23, 2002 at 19:52:13 from (64.12.97.13):

In Reply to: Where can I get a sleeve puller? posted by Doug Moser on November 22, 2002 at 16:07:20:

go to your local steel warehouse and have them slice a cold rolled bar off thats 1/16" inch bigger than your pistons 1 inch long. drill a hole in it for piece of threaded rod. Get a piece of pipe thats larger than you piston and put a piece of plate with a hole on top of it with the threaded rod down through it. Put the cold rolled bar on the bottom of the sleeve and tighten with a big wrench.

Follow Ups:

• Re: Re: Where can I get a sleeve puller? Doug Moser 21:00:17 11/23/02 (1)
  • Re: Re: Re: Where can I get a sleeve puller? Kelly C 07:23:33 11/24/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Where can I get a sleeve puller? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]