Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Ok what am I in for now? or Oh no! that bolt fell into the trans.(MW hand clutch for H )
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on November 21, 2002 at 18:50:20 from (63.171.43.140):
In Reply to: Re: Re: Re: Ok what am I in for now? or Oh no! that bolt fell into the trans.(MW hand clutch for H ) posted by Steve - IN on November 21, 2002 at 18:28:40:
Oh yea, I remember that. It was the hottest up at the top of the barn. Gramps barns were tin. 1st time I ever baled with him, my cousin and I were 8 years old. We would each stand on one side of the bale chute. When a bale would come up, we each would grab one side and drag it to the back of the rack. I think we could only get them about 4 high. The last time I baled was Aug of 1982 the day before I went to the Army. Last summer Grandma sold the last of the land. I wish she hadent done that. Oh well time to get my own. my son is gona need some baling memories.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|