Farmall & IHC Tractors Discussion Board |
Hey jal and STEVEN H! parts for ya!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on November 08, 2002 at 12:40:46 from (12.15.56.167):
jal- I have a float from an F-12 or F-14 carb. It looks decent, but has that liquid sound inside it when I shake it. You should be able to drill a small hole and drain it out, then solder it shut. Give me your address if you want it and I'll send it. Pay shipping and whatever you think is right for the float. STEVEN H - I found 2 firecrater pistons (like pictured below). The number on the side is 4078 and there is also a Z on the side. The part # on top is 374313R1R and there is also a number 7-16 on top. They look useable, need to be cleaned up. The rings and piston pins are with them. They are 3 3/8 inch (3.41 inches). Cost $5 plus shipping. Email me your address if you want them. 
Won't be back in town till Tuesday to get stuff shipped out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|