|
Farmall & IHC Tractors Discussion Board |
Re: Re: IH 240 Tractor - Rebuild or not?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Herold on November 04, 2002 at 15:55:46 from (205.188.209.78):
In Reply to: Re: IH 240 Tractor - Rebuild or not? posted by Bama Binder on November 04, 2002 at 11:44:37:
Steven and Bama,
Thanks for the responses. This will obviously save me considerable money and time. The oil pressure did run a bit on the low side (only about 1/3 of the gage) but there was considerable sludge in the engine when I took the head off. I was going to drop the pan and clean/check the pump suction line and screen. Should I replace the pump in your opinion? To answer Steven's question, the cylinder walls look fine, very little ridge on the top. I cleaned the pistons and they look good, there is a small amount of indentions on one side of them (pinging?) but not serious.
Again, Thanks guys! Joe
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
