|
Farmall & IHC Tractors Discussion Board |
Re: 1947 Farmall A cold start
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sean in Calgary on October 29, 2002 at 13:04:46 from (216.94.7.66):
In Reply to: 1947 Farmall A cold start posted by Mark on October 29, 2002 at 09:45:04:
This is more of a warning than what you should do. Lot's of folks might just tell you to grab a can of Hot Start (ether). Please, don't. First of all, this stuff is REALLY volatile so it is tough on your older engine. Second, because it is so volatile, it can be pretty dangerous. Last winter I watched a guy put parts of his intake manifold into low earth orbit. The engine was somewhat older (as our tractors are) and my guess is that he had an intake valve hang open slightly. When it fired, the intake manifold was full of ether. Not a pretty sight at all. Luckily, he was just badly scared not burnt or injured. Plus he was short one carbeurator and manifold.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|