Farmall & IHC Tractors Discussion Board |
Re: farmall (a) clutch, which way does it go ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on October 28, 2002 at 16:50:45 from (64.228.13.62):
In Reply to: farmall (a) clutch, which way does it go ? posted by Jonathan Mitrgon on October 28, 2002 at 05:26:09:
Ace is right I found out the hard way. Just about time I was ready to do actual split of tractor, 3 friends came along. As we removed the presure plate I laid the old clutch disc on blocks supporting rear of tractor, facing the way it came out. I went across shop for new clutch and presure plate. When I turned around one of my buddies had picked up clutch disc and was flipping it over and over looking at it. Tractor was bolted back up and clutch in 1.5 hours. Later that evening I split the tractor by myself to turn the clutch disc over. There are some jobs where a little patience is worth a lot.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|