Farmall & IHC Tractors Discussion Board |
Re: Regular serial number
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on October 27, 2002 at 18:41:22 from (63.147.130.5):
In Reply to: Regular serial number posted by Roy Thomas on October 27, 2002 at 15:41:53:
F-20's have serial number on serial number plate, frame side rail, and also on the side of engine. These 3 numbers should all be the same. I have heard story's about parts getting mixed up at factory and thus the numbers didn't match up but I'm a little specticle that that happened. When I see numbers that don't match up I am pretty certain that the tractor has been pieced together over the years. Like 2 or 3 tractors put together as one. F-20 number plates are on backside of tool box and I am not real certain where the number plate should be on a regular but I would almost think the regular would be like the F-20 and have the 3 number locations as said above. If missing the number plate look at the frame rail number and see if you can find the same number on engine, if so then it would be safe to say that it is the serial number and the missing plate would of had the same number on it and thus that number would be serial number. Prefix letters may have not been stamped in frame and engine but the complete number would have been. I would be willing to bet that, it is the serial number.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|