|
Farmall & IHC Tractors Discussion Board |
Re: oil leak on Super C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on October 24, 2002 at 11:36:35 from (152.163.189.203):
In Reply to: oil leak on Super C posted by LarryL on October 24, 2002 at 08:04:07:
Could be the steering gear, or the front engine seal. On my C it was the steering gear. Even though the steering gear does not hold much, a little oil goes a long way. The steering gear is not a difficult fix. The worm gear screws out the front after you disconnect the steering shaft behind the front bolster and remove the big plug in the front of the bolster. Then you take off the front pedestal to which the axle and wheels are attached. The pedestal is held on by four bolts. Then four more bolts hold in the steering gear assembly which consists of the retainer, the lower bearing and seal holder the main steering shaft, the worm wheel gear and the upper bearing. This comes out as a unit. Once out, you can disassemble and replace bearings and seal as needed.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|