Re: Cub Repairs

Posted by Bigdog on October 22, 2002 at 23:29:19 from (157.254.98.201):

In Reply to: Cub Repairs posted by Cubing in Tx. on October 22, 2002 at 20:45:50:

Manuals are availble from Case IH dealer or from Binder Books. Check the link for the answers for several of your questions. As far as your starting problems, check the timing. Should be @ TDC when firing. Crank pulley comes off with a lot of heat and a good puller but make sure you're not pulling on just the flange of the pulley. Use a puller that reaches in far enough to get into the "meat" of the pulley or put some backing plates behind the pulley to pull against. For fluids: use 90 wt. or Hy-tran in trans / diff., finals. 90 wt. in steering box. 30wt in air cleaner and 30 wt or 10W30 in engine (your choice). Can't recall fuse amperage right off hand and I'm not near my manual, but I think it's a 20 amp.

• Cub FAQs

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Cub Repairs Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]