Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Super C Oil Leak from Valve Pan Filler Filter
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by REA on October 22, 2002 at 05:43:13 from (170.224.224.134):
In Reply to: Re: Re: Super C Oil Leak from Valve Pan Filler Filter posted by Dhuth2 on October 21, 2002 at 21:09:12:
Hi Dhuth2, I have gone through the engine about 1 1/2 years ago with a man that is suppose to know engines. Now I am woundering what may be wrong & think that I have to go through the whole engine again? It seemed to run good at first then the head started to leak, I retorqued the head and that didn't help, took it off found the sleaves about .008 about .004 higher than should be, applyed Indian Head gasket sealant, stopped the leak but I still have this blow-by problem. Thanks for your input. Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|