|
Farmall & IHC Tractors Discussion Board |
Re: A swap from a IH H to a J.D. A or G ?????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on October 19, 2002 at 14:38:10 from (64.68.189.140):
In Reply to: A swap from a IH H to a J.D. A or G ????? posted by carl on October 19, 2002 at 14:20:08:
No problem making an H pull. Bore the engine out to accept the sleeves from a 350, this will give more cubic inches and power. Find a 350 LP intake/exhaust manifold and carburetor. Put on a 350 LP head for more compression. Increase the timing and run premium fuel. If you have traction and are running out of power in 1st gear, get the low-low gearset and put it in. If possible speed the engine up, it will handle 2000 RPMs easy if it is tight. I'm sure there are more ways to make power but these are the easiest and most cost effective to start with.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
