|
Farmall & IHC Tractors Discussion Board |
Re: Need W12 Brake Info
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Karl O on October 15, 2002 at 15:46:07 from (198.76.182.140):
In Reply to: Need W12 Brake Info posted by tractor_gal on October 15, 2002 at 09:27:32:
That's the problem, all right. The brake is located in that big sheet metal pan in front of the axle. Inside the pan is a heavy sheet metal drum. The brake shoes are stuck to it, and usually are destroyed when you pull the drum off. Remove the big nut in the center of the drum, and use a puller (or pry around the edges of the drum) to get it off. Sometimes you can whack the drum with a hammer while pulling it and get the shoes to release before they break off. I haven't checked yet; I hope Rice has replacement shoes.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|