|
Farmall & IHC Tractors Discussion Board |
Is this to much?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JR in AL on October 12, 2002 at 15:14:09 from (68.17.166.30):
I hate to do it, but I need to sell my dad's H's.
They will make good work tractors. Between the two of them they might even make one good restoration. Went to show them to someone today and they were cantankerous. I had them cranked last month and running but today both carbs act like they need a rebuild. One leaks fuel out of the choke plate shaft and the other only runs if you continually play with the choke.
I am kind of attached to these tractors so I am not sure if the price is fair ( I don't want to cheat the buyer or myself). I offered the 2 tractors at 1500.00 (total for both) The rubber is good on both and I thought that that might help but I just don't know. Suggestions for price and on the carb issues would be appreciated. Anybody else around birmingham or gadsden AL?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
