Re: 400D Wiring Issue

Posted by Bob M on September 23, 2002 at 07:24:35 from (165.170.128.66):

In Reply to: 400D Wiring Issue posted by David Bean on September 22, 2002 at 21:22:03:

David - Sounds like a problem in the manifold switch - i.e. it is shorting to ground.

The manifold switch contacts should be closed with the decompression lever in the gas (start) position, and open in the diesel (run) position. And both manifold switch contacts should be isolated from ground in either starting level position. Incidentally the purpose of the manifold switch is to shut off current to the coil when running in diesel mode to reduce wear on the points, plugs etc. when they are not needed.

Nice diagrams BTW!

Follow Ups:

• Re: Re: 400D Wiring Issue David Bean 15:34:28 09/23/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: 400D Wiring Issue Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]