|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Time to rebuild the upper Bolster on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on September 18, 2002 at 15:45:10 from (24.169.120.138):
In Reply to: Re: Re: Time to rebuild the upper Bolster on H posted by CD on September 18, 2002 at 13:47:08:
CD - Your bolster shim question is a good one. The shim does NOT appear in my SH parts catalog. However it's definitely an IHC casting, it carries an IHC part number and my SH has one (the one in the photo). But my father in law's SH does not have one. I've begun looking at other H's and SH's at shows - observed most of them do not have the shim, but every so often I spot one that does. Go figure...
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
