Re: Help! New Rebuild is too tight!!

Posted by Mike ISW on September 17, 2002 at 15:43:39 from (64.12.97.13):

In Reply to: Help! New Rebuild is too tight!! posted by Jason on September 17, 2002 at 13:03:47:

I just rebuilt a H engine recently. I was unable to turn bare engine over by hand after installing pistons. I think it would be too loose if you could do this. As mentioned were all clearances measured? Ring end gaps,piston skirt clearance,rod and main bearing clearances? Before rebuild i could turn engine over with one finger. I'll be interested in other comments and Good Luck!!

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Help! New Rebuild is too tight!! Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]