|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: C Farmall Governor Bushing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by geoff gauger on September 05, 2002 at 05:35:05 from (12.155.240.196):
In Reply to: Re: Re: C Farmall Governor Bushing posted by Brian Schmidt on September 04, 2002 at 20:29:50:
Go to the link, I have pictures of the installation tool and installed bushing. South Carolina is a bit far for tool sharing but you can make a driver if you have access to a lathe. The important thing is to fully support the I.D. of the bushing. If you want to make the tool (the handle is a luxury and not absolutely necessary) I can measure it up and post the dimensions. It turned a tricky job into a no-brainer for me. http://albums.photo.epson.com/j/AlbumIndex?u=4045430&a=30303574&f=0
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
