Re: Changing the mag condenser on my H

Posted by Mike Schotte on September 02, 2002 at 15:10:16 from (209.246.131.51):

In Reply to: Changing the mag condenser on my H posted by Ted Goss on September 02, 2002 at 14:36:47:

Hi Ted,

To remove the condenser on the H4 you need to do the following:

1) Remove kill switch wire, and unscrew the brass grounding post from insulated washer.

2) Remove coil cover. You will be able to see the top of the condenser, laying sideways below the front of the coil. There is a vertical screw with a hold down clip that retains the backside of the condenser and grounds it to the mag body. Remove this.

3) Remove the two screws on the backside of the mag and remove the oval access plate. Behind the plate is a round hole that the condenser slips out of. It goes without saying that the magneto will have to be removed from the tractor for you to access this side of the mag.

Re-assemble in reverse order. Good luck!

-Schotte

Follow Ups:

• Re: Re: Changing the mag condenser on my H Diesel Don 18:19:04 09/02/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Changing the mag condenser on my H Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]