|
Farmall & IHC Tractors Discussion Board |
Re: M PTO Assembly Installation. Mission Success!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob in SE Nebraska on September 02, 2002 at 12:43:53 from (162.40.71.89):
In Reply to: M PTO Assembly Installation. Mission Success! posted by The Red on September 02, 2002 at 09:21:04:
Red, Nothing like success!! The only time I had to deal with removing the PTO was on an H and I had the platform off at the time. With the platform removed it is a simple matter to reach down and align that shaft but I thought it must be a real problem to get that job done if you didn't have the top of the transmission off. Thanks for the information. Bob
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|