|
Farmall & IHC Tractors Discussion Board |
Re: Re: F20 Hydraulic pump
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lou on August 30, 2002 at 10:27:30 from (12.29.175.2):
In Reply to: Re: F20 Hydraulic pump posted by Bill Smith on August 29, 2002 at 19:40:55:
Thanks Bill. Sounds like your tractor and mine have the same setup. You are right. There is only room for one, either the transmission or the road gear, but not both. My pump mounts in between clutch and transmission too and it is a heavy hunk of iron. I have a road gear on the tractor now but hardly use it. Besides that, where I live (west of Pittsburgh) driving a tractor on the road is just not safe. I'd rather have hydraulic power than speed. The increase in speed with the road gear is not that much anyway. I can hardly tell the difference between road gear mode vs 4th gear.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|