|
Farmall & IHC Tractors Discussion Board |
Re: Re: Help, Oil Change reveals problem, Super C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don on August 28, 2002 at 21:56:02 from (208.11.82.186):
In Reply to: Re: Help, Oil Change reveals problem, Super C posted by Paul Shuler on August 28, 2002 at 14:55:53:
Paul, unless I am misunderstanding you, could you give a little more information on where this hydraulic pump is located and how it would cause extra oil in the crankcase. The stem was twisted off for checking the high level of the engine oil. This got me to thinking that the previous owner was unsure of himself and was adding oil when he should not have been. For your info my parts catalog for this tractor shows what it calls a ring packing, cylinder sleeve and is shown at the bottom of the sleeve. The parts counter where I purchased this manual said this manual was for the super c even though the first page says farmall c and I was given a small sticky tab to affix on this first page saying Super C. However, this manual also shows a gasket on the oil filter and my tractor does not have a gasket. Where the filter case makes contact with base there is a tappered groove. Makes you wonder. (I just now noticed that the 2nd and 3rd pages of this manual does say super c on them)
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
