Farmall & IHC Tractors Discussion Board |
Re: Leaking rear seal on a C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greensboro george on August 28, 2002 at 11:36:02 from (162.33.106.250):
In Reply to: Leaking rear seal on a C posted by Dave K on August 26, 2002 at 18:22:20:
Dave, I had the same problem. Get new oil seals,gaskets and felt washers from IH dealer. Pull off the wheels, remove the 4 bolts that hold the small outside housing piece (it has the zerk in it)and slide it off the axle. remove the old seals and washer, clean and grease the axle, and carefully slide new parts on. Grease the zerk! No more leaks! Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|