Farmall & IHC Tractors Discussion Board |
756 diesel thermostat problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Redlon on August 04, 2002 at 18:25:48 from (24.247.151.18):
Hi everyone, I am nearly finished with a complete out of the tractor overhaul on the engine of our 756 diesel (german) tractor. This is aprox a 1968 model and it has the older canister type in line thermostat. we have determined that this is stuck open. Thinking back now to when we ran this tractor it never did seem to get up to any good temperature on the gauge except while plowing with 5-16's. I am wondering if anyone else has had one of these fail and knows where I can get one. According to my repair manual it is stamped 75 in two places and that converts to 167 degrees F. I called an IH dealer in Wisconsin but with no luck in locating one. Later models of the same tractor line had the thermostat mounted in the more traditional manner in the discharge casting of the pump with a cap much more like a car. Here is the IH part number if any of you have access to old parts please let me know. 3 055 998 R91 a complete replacement body assembly is listed as 3 055 190 r11 thanks, Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|