|
Farmall & IHC Tractors Discussion Board |
Injector pump oil?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John in CT on July 27, 2002 at 18:08:08 from (64.252.69.204):
I am trying to start a Hough Payloader with an IH UD9 engine. I think it is the same as the WD9 and TD9. It has been sitting for about twenty five years. I did fire it on silicone when I had the carb off to rebuild it. I plan on dumping the old oil and fuel along with the filters. I opened the petcock on the injector pump and diesel fuel came out. I think that there is supposed to be oil in the injector pump. What is the correct amount to fill the pump? Does the fuel in the pump mean there is a bad seal, or am I not checking it properly? Thanks
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|