|
Farmall & IHC Tractors Discussion Board |
Super C starting and charging ok now
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD Humm on July 26, 2002 at 02:54:54 from (67.27.231.154):
Went over some connections on the SC last night after work (in the 103 degree heat here in eastern Kansas), recharged the battery the night before. Also looked at the generator (yes it is a 12v generator, not alternator as I think it looks better), had some high mica between the commutator bars so I dragged that out with a cutter that I use on elevator motor/generator sets at work. Also had some copper in one of the slots which had those two shorted. It now charges a lot better than before and starts the second it starts to turn over. So I guess we are okay for a while now. Going to load it up and go to Adrian, Mo. tomorrow to a get together, featuring Massey Harris at this one. Hope they don't mind a different shade of red. Going to meet up with SWMO 1206 while there and HD. Will take some photos and post a few.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
