Farmall & IHC Tractors Discussion Board |
Re: Help with M steering bolster rebuild please
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Theman on July 22, 2002 at 07:09:50 from (12.19.86.5):
In Reply to: Help with M steering bolster rebuild please posted by John S. on July 21, 2002 at 16:32:09:
The cross for the steering U-joint for my H was available at Tractor Supply Co. It even came with the little C-clips that hold the needle bearing caps in too. I believe the same one is used on the M. I tried to get one at a local drive shaft place first and he was shaking his head when I walked in the door...never took a measurement, never opened a catalog. Take your yoke with you as the crosses in the store are generic. They have the size (width and diameter) printed on the box but nothing else to tell you what it fits. Note: Be sure the grease fitting in the cross faces the opening in the hood. It can be put in backward requiring you to remove the hood to give it a shot of grease.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|