|
Farmall & IHC Tractors Discussion Board |
Re: Re: Battery Voltage
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by karl f on July 02, 2002 at 23:09:01 from (63.21.83.33):
In Reply to: Re: Battery Voltage posted by BIG JOHN on July 02, 2002 at 18:38:54:
there was a post in a thread in one of these YT forums recently about how to charge an 8v w/ a standard battery charger. something about a 3 amp load in series with the battery with the charger set on 12v. also if you have an older farmall with the charge rate light switch (no regulator) it should put out plenty to keep the 8v charged. however the 8v batts are lower cca than the better 6v that you can find these days. smaller tractor like an A or H should be fine with 6v to begin with. good luck! -karl
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|