Re: H Lube system question

Posted by Farmer Bob on July 02, 2002 at 21:08:52 from (66.152.73.237):

In Reply to: H Lube system question posted by Christopher Zahrt on July 02, 2002 at 15:42:19:

Christopher, Don't go to that length of trouble until you have done the following. First, crank the engine over with the starter (Switch off) until you see some oil pressure building on the guage. Remove the valve cover and verify that oil is getting into the rocker arm assembly. Carefully remove the breather tube from the front of the head and the housing atop the governor. Check to make sure that tube is not clogged with old gunk. I use a length of #12 copper wire to push through these to clean out any sludge. Blow it out with compressed air. Reassemble everything and you should be good to go.//FB

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: H Lube system question Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]