|
Farmall & IHC Tractors Discussion Board |
Driveshaft/Tranny main shaft yoke on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Obie NH on July 02, 2002 at 06:47:05 from (64.12.103.21):
I have put all new bearings and seals in the differental and tranny and it has been apart for about two months.Now that I am putting it back together I have noticed that the trasmission yoke did not have a bolt in it to conneact to the main shaft.I dont recall taken one out when I took it apart.Manual shows some kind of washer but no bolt.The end of mainshaft is threaded as one should be in there.If a bolt does go on it there must be some sort of an large washer to go on to the yoke first.This is a 41 H with no hydrolics.Thanks in advance Obie in NH
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|