|
Farmall & IHC Tractors Discussion Board |
Re: Re: Confusion about pushing snow with a blade
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by added note.. on June 24, 2002 at 06:25:48 from (65.57.20.214):
In Reply to: Re: Confusion about pushing snow with a blade posted by Gene on June 24, 2002 at 06:15:02:
Gramps: I should have mentioned I do have the blade on for foward. Also note that the snow does pile up very deep ahead of the blade.. but remember that snow is much lighter than DIRT so let it pile up. Also a slight angle allows the snow to excape to the side when it piles up ahead of the blade. No it's not perfect but is does get the job done. Money no issue, get a blower? Good luck. G.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|