Farmall & IHC Tractors Discussion Board |
Re: Re: Hydraulic Valve/Pump Rebuilders???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jmyt_47 on June 21, 2002 at 07:28:18 from (170.92.1.104):
In Reply to: Re: Hydraulic Valve/Pump Rebuilders??? posted by K.B. on June 20, 2002 at 20:35:10:
Ditto. I have a 300 also. You can get all the parts from the dealer for your valves. You can also get the shaft seals for your pump. You'll need a special tool to install the garter spring if you totally disassemble your valves and rebuild them. If the pump is in need of a total rebuild, your dealer could get you a new replacement. Or you could try a national hydraulic repair shop like Force America. They have locations all over the U.S. 1-800-328-2732.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|