Farmall & IHC Tractors Discussion Board |
Re: Re: Removing a Piston from Below
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff on June 09, 2002 at 08:49:47 from (207.140.228.27):
In Reply to: Re: Removing a Piston from Below posted by Steven@nd on June 08, 2002 at 13:40:24:
Steve, Thanks. I can only hear the knock when I'm on the manifold side of the engine, and if I get over five feet away I don't hear it. I think it even quiets down a little after I drive it around. I don't plan to work it; it MIGHT run an hour a week in the summer, but that's it. The reason I think it's the (3rd) piston pin is that I had the head refurbished, put in new rings and rod bearings, and when I put the pin back into the rod/piston, it went in without any effort; the others required some tapping with a rubber hammer. I made a note of this, but like an idiot, I didn't take care of it (mainly because that's how the engine ran before and it never knocked; I figured it would work okay when I put it back in). I would like to get rid of the knock, but I JUST put everything back together.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|