Farmall & IHC Tractors Discussion Board |
Re: attn:RedTed
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RedTed/MO on June 09, 2002 at 07:17:28 from (63.71.128.107):
In Reply to: attn:RedTed posted by steve on June 08, 2002 at 20:19:29:
Steve: There's four bolts that hold the unit to the the tractor. From either side and before you do anything, you will see three recesses and a bolt head in each. Nothing to worry about; what they're for will be evident once you get the unit off: there's a bottom plate, bolted to the unit with 10 or 12 bolts,... and the recesses accommodate those bolt heads. Free of any attachments to the rockshaft arms (duh!), and disconnected from the pipes to and from the pump,... and drained (as much as it can be) of fluid,... take off those four bolts. The unit is free of the tractor and can be carried to your workbench. Careful -- altho' maybe you're younger and stronger than I am -- that sucker is heavy! One other thing that you might do before you actually take the unit off the tractor. On the rockshaft, there's a nut on either end. A pretty good sized one. Takes maybe an inch-and-seven/sixteenths socket. Those are going to be on very, very tight. You'll get the leverage you need in taking them off -- and I needed a three-foot breaker bar(!) -- if the unit is still attached to the weight of the tractor. Take those nuts off before you take the unit off the tractor,... and, with a puller of some sort, then take those first outside pieces off the rockshaft. Okay? Then you're good to go to the bench. And, when something looks puzzling, to get back in touch with me. I'll watch the forum and stay with you. Keep on wrenching red! RedTed/MO.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|