Farmall & IHC Tractors Discussion Board |
300U mystery valve
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matt on June 07, 2002 at 20:16:51 from (12.82.71.21):
My 300 utility has 4 spool valves bolted to the resevoir/manifold,two stacks of two valves. Three are the "Hydra-Touch" spool valves ( 2 for the loader, 1 for the 2-point )The forth mystery valve is different and it is spewing hydraulic fluid. This valve is in the rearmost set sandwiched to the resevoir,has no actuator 2 spring loaded spools. It is ported out the back 1 port to the power steering 1 to a loop that hits the 2 outside valves (supply?) Is this perhaps a pressure regulating valve for the power steering? I replaced the "o"rings but it keeps blowing the snap ring of the vertical spool out and hydro fluid to the ceiling of my shed. Hope someone has some tips, I'm new at this but getting frustrated
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|