|
Farmall & IHC Tractors Discussion Board |
Re: Designing your own 3 pt. hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greg r on June 06, 2002 at 20:02:26 from (208.34.108.62):
In Reply to: Designing your own 3 pt. hitch posted by Hal Davis on June 06, 2002 at 09:49:14:
Hal, If you go to
http://asae.frymulti.com/newresults.asp
and look at the abstract for ASAE S217.11,
it appears S217.11 might have your
information. There is a nice picture of a store bought one at
http://www.saginawcountytractor.com/
- click products then farmall
maybe you could get some ideas from it. You probaby want the lower arms narrower in the
front than in the back. Also, lowering the
top link mount causes the back of the implement
to rise more when lifted, so maybe you want 2 or
3 top link mount locations. Sorry I don't know
the dimensions for your H as my experience
comes from designing one for a smaller tractor. Greg R
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
