Re: HELP! I need to unstick my 300U adjustable axle!

Posted by Hugh MacKay on June 04, 2002 at 01:55:27 from (216.208.58.115):

In Reply to: HELP! I need to unstick my 300U adjustable axle! posted by joe on June 03, 2002 at 20:01:25:

There may not be any method thats not extreem. I had to take axle assembly from under 130 hang it end ways from ceiling with wheels on. We then heated the outside tube with two torches. Using a block of wood on spindle shaft we used a 8 lb hammer. It wasn't until we had that entire outside tube red that it came free. We had so much heat on that, we started to get nervous that we might burn building down. What came out from between the tubes was rust just like sand. At time we wondered if we may have taken strengh out of tubing. Well my friend it is back on tractor and that was 11 years ago.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: HELP! I need to unstick my 300U adjustable axle! Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]