|
Farmall & IHC Tractors Discussion Board |
Re: Power steering for my H...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jmyt_47 on May 29, 2002 at 07:07:44 from (170.92.1.104):
In Reply to: Power steering for my H... posted by Steven@nd on May 28, 2002 at 14:31:04:
I checked the M&W manual on the charlynn powersteering pump install- the photos are terrible becaus it was a copy. It appears the the pump has a bracket that mounts off the exhaust manifold bolt and a bolt off the water pump. The powersteering pump pulley is at the same height as the generator, just on the other side of the engine. the belt is routed in a triangle pattern around the generator, water pump, and the powersteering pump. The belt goes over the top of the radiator brace. The instructions say the brace is bent to a new template supplied with the kit. You could try calling Force-America for more info on the setup- they still sell the powersteering pump, reservior, and torque generator. I'm not sure about the brackets though. Here's their Bismark, ND number 1-800-624-7568.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|