|
Farmall & IHC Tractors Discussion Board |
Re: Re: Lower Bolster Angle - FORWARD OR BACHWARD????????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on May 23, 2002 at 19:24:14 from (65.219.138.5):
In Reply to: Re: Lower Bolster Angle - FORWARD OR BACHWARD???????? posted by BIG JOHN on May 23, 2002 at 19:00:03:
I hate to be the contrarian here, but the bolster on my B was angled forward when I bought it, and sp when I had it apart I looked around at other tractors to see if that was right and saw them both ways so I did an experiment. I tried it forward, then took it off and tried it backward. I didn't notice any appreciable difference in the steering. Of course, my steering U-joint is shot, so I have a lot of free play, so that didn't help my experiment much. I left it angled back, for the reasons the others have outlined, but in my case it didn't seem to matter.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|