|
Farmall & IHC Tractors Discussion Board |
HELP!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Vinnie on May 21, 2002 at 06:04:30 from (65.162.105.137):
Just had my carburetor on my '42 "H" rebuilt, Yesterday's Tractors did a fine job rebuilding/refurbishing it. Attached it to the manifold, tightened all the fasteners and fired it up. Wallah, runs like crap! I used the service manual for the set up proceedures, and tried to tune the beast. To make a long story short, it doesn't set up. I'm not a mechanic and can't troubleshoot myself out of a wet paper bag. It will speed up then settle down for a few seconds then resume the Indy 500. I've noticed that when I remove oil bath air cleaner cover and place my hand completely over the inlet, it will not die like an automobile will when you choke it and will smooth out to an "almost idle". I'm at my end, can anyone give me any pointers, all help is greatly appreciated..Regards and sorry for the detail{s}.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
