|
Farmall & IHC Tractors Discussion Board |
Lucky or ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall_Man on May 19, 2002 at 21:51:27 from (32.97.110.142):
Well, I got the front bolster rebuilt on my '46 H and filled it with 90W. Not a leak anywhere!!! I was as nervous as a long-tailed cat in a room full of rocking chairs about doing this after reading some of the archives on this subject. Maybe it's 'cause I cheated a little on this. I took the bolster off the tractor and worked it over while it was laying on the floor. This seemed to make the job a whole lot easier, at least for me. Got the radiator boiled out and a small leak fixed and the cooling system holds water, too. I guess the next task is to replace the bull gear seals and the front tranny seal - they leak quite a bit. Wish me luck on this! FM
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|