Farmall & IHC Tractors Discussion Board |
Re: What size tandam disk for 1940 H?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gy3020 on May 12, 2002 at 11:43:08 from (209.151.96.69):
In Reply to: What size tandam disk for 1940 H? posted by Two Bit on May 11, 2002 at 19:46:11:
I believe I would recommend getting a 6 to 7 foot disk to just plow the rear tires out. You don't want to overload the tractor. My dad has a B John Deere and he has a 6 ft, KBA disk he bought for it when he farmed. It is a good match. I too am going to be trying to get ahold of a H and a B Farmall this year. I am partial to JD Green but I do want a couple of red ones around too. I really like them all but my primary color is green. If you stay to width of just plowing the rear tires out you should stay safe and like has been said before 16 to 18 inch blades. Hope this helps!
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|