Farmall & IHC Tractors Discussion Board |
Re: 1468 STRAIGHT PIPED
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by c.b. on May 03, 2002 at 06:18:01 from (207.54.105.157):
In Reply to: 1468 STRAIGHT PIPED posted by IH_1468 on May 02, 2002 at 19:25:31:
Straight pipes generaly give an engine a little more horse power. Like hot rodders do with header type exhaust manifolds and no mufflers. Some say its hard on the exhaust valves , they close a little harder & faster. Most engines need a little exhaust back pressure to run smoother. But what the heck try it, It should realy sound mean and tough with dual straight pipes. I hope you have a good pair of ear muffes to wear, If not you will soon be looking for a pair. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|