|
Farmall & IHC Tractors Discussion Board |
Re: 706 Gas Melted Spot in Piston
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on April 27, 2002 at 20:25:59 from (216.196.13.66):
In Reply to: 706 Gas Melted Spot in Piston posted by Farmall Don on April 27, 2002 at 17:57:28:
Hone the hole and like steve said and fix it . what happed is that some time it got real hot on 6 because it either leaned out or your total advance timing is not wright or you got a dose of diesel fuel in the gas . 706 gasers requier 93 octain min. fuel and i have said this before 87& 89 octain gas burns hotter and faster then 93 and if the distator is in need of repair and you lug the engine it gets real hot real fast and does not show up on the temp. gauge. and the end results are what you have. BEEN THERE DONE THAT .
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
